| |
OS-5100RA |
OS-5100RB |
| 阴极管 |
配置和有效视频 |
6 inch rectangular screen with internal graticule: 8x10DIV (1div=1cm), marking for measurement of rise time. 2mm subdivisions along the central axis |
| 加速电势 |
+11.5kV approx (Ref. cathode) |
| 荧光器 |
P31 (Standard) |
| 聚焦 |
Possible (with auto - focus correction circuit) |
| 旋转线迹 |
provided |
| 比例照明 |
Variable |
| 亮度控制 |
provided |
| 高强度Z轴输入 |
输入信号 |
Positive going signal decreases intensity + 5Vp-p or more signal cases noticeable modulation at normal intensity settings |
| 频宽 |
DC to 2MHz (-3dB) |
| 触发耦合 |
DC |
| 输入阻抗 |
20kOhm - 30kOhm typical |
| 最大输入电压 |
30V (DC + peak AC) |
| 垂直偏移 |
频宽 |
DC Coupled (DC耦合): DC to 100MHz (2mV/DIV: DC to 50MHz)
AC Coupled (AC 耦合): 10Hz to 100MHz (2mV/DIV: 10Hz to 50MHz) |
| 模式 |
CH1,CH2,DUAL,ADD,ALT
CHOP,CH2 INV, QUAD |
CH1,CH2,DUAL,ADD,ALT
CHOP,CH2 INV for OS-5100RB |
| 偏转系数 |
2mV/div to 5V/div in 11 calibrated steps of a 1-2-5 sequence.
(For OS-5100RA: CH3,CH4: 0.1V/DIV,0.5V/DIV)
Continuously variable between steps at least 1:2:5 |
| 准确度 |
+/-3% |
| 输入阻抗 |
Approx, 1Mohm in parelle1 with 25pF |
| 最大输入电压 |
Direct 400V (DC + AC Peak) (with probe: refer to probe specification) |
| 输入耦合 |
DC- GND - AC |
| 延升时间 |
3.5ns or less (2mV/DIV : 7ns or less) |
| 通道1输出 |
50mV/div into 50ohm : DC to 20MHz (-3dB) |
| 极性逆向 |
CH2 only |
| 信号延时 |
Delay cable supplied |
| 水平偏移 |
显示方式 |
A, ALT ,B, B TRIG'D ,X-Y |
| A 时基 |
0.5us/div to 0.5s/div in 22 calibrated steps 1-2-5 sequence, uncalibrated continuous control between steps at least 1:2:5 |
| 锁定时间 |
Variable with the holdoff control |
| B 时基 |
0.05us/div to 50us/div in 19 calibrated steps 1-2-5 sequence |
| 延时扫描定位调节 |
1 div or less to 10 div or more |
| 延迟拌动 |
better than 1:10000 |
| 扫描放大 |
10 times (maximum sweep rate : 5ns/div) |
| 准确度 |
+/-3%,+/-5% (0℃ to 40℃) additional error for magnifier +/-2% |
| 触发系统 |
触发模式 |
AUTO, NORM ,TV, SINGLE |
| 触发源 |
LINE, VERT, CH1,CH2,CH3,CH4 |
LINE, VERT, CH1,CH2 |
| 耦合 |
AC, DC, HF, REJ, LF REJ, LF REJ, TV-V, TV-H |
| 倾斜率 |
+ or - |
| TV-V, TV-H |
At least 1 div or 1.0Vp-p |
| 外部触发输入阻抗 |
1MOhm (in parall1 with approx. 25pF) |
| 灵敏度和频率自动或标准 |
DC-10MHz 10MHz-100MHz
INT 0.5div 1.5div
EXT 0.1Vp-p 0.3Vp-p
VERT 0.5div 3.0div |
| 最大输入电压 |
400V (DC + Peak AC) |
| X-Y 轴操作 |
X-axis (X轴) |
(Same CH1 except for the following) Deflection factor; same as that of CH1/Accuracy : +/-6%/Frequency response: DC to 2MHz (-3dB) |
| Y-axis (Y轴) |
Same as CH2 |
| X-Y轴相位相差 |
3º or less (at DC to 100kHz) |
| 直读功能 |
游标计数功能 |
△V, △T, △1/T |
| 自动设置 |
Enable |
| 频率计显示 |
Enable (only on Autosetup) |
| 面板设置显示 |
AC/DC/GND, V-MODE, CH2 Invert, Volts/div, *10 mAG, H-DSP MODE, TIME/DIV, trg source |
| 解析度 |
1/25 div |
| 校准器 |
可调探针 |
approx. 1KHz frequency, 0.5Vp-p (+/-2%) square wave, duty ratio:～50% |
| 电源供应 |
输入电压范围 |
90-250VAC (fuse : 1A 250V) |
| 电压频率 |
48-440Hz |
| 功率 |
Max.50W |
| 物理参数 |
尺寸 |
328(W)×153(H)×392(L)mm |
| 重量 |
8kg |
| 环境参数 |
温度 |
Temperature range for rated operation: +10℃ to +35℃ (+50℉ to 95℉)
Max, ambient operation temperature: 0℃ to +40℃(+32℉ to 104℉)
Max, storage temperature : -20℃ to +70℃ (-4℉ to +158℉) |
| 湿度 |
Range for rated operation: 45% to 85% RH/MAX, Ambient operating humidity: 35% to 85% RH |
| 其他 |
附件 |
operator's manual 1 |
spare fuse 2 |
| 电源 |
power cord 1 |
test probe (option) 2 |